We accept credit cards, personal checks and money orders.
Page Title
Measuring for K-9 Coolers
SilverShadeMesh, PO Box 895, Winnebago, MN 56098
(507) 893-3646
*Products and prices subject to change without notice.
Sizes:
- *Not intended for use as a "turn-out" jacket *
Click for
more pictures.
* For extra cooling - dip K-9 Cooler in water - wear wet.*
Standard K-9 Cooler sizes are made in 2" increments... (size 8"- size 10"- size 12', etc.)
1..
3.
2.
1.Back Measurement= SIZE - From base of neck to tail, or as desired for coverage.
3. Jacket Depth-measure from one elbowover the shoulders to the other elbow.
2. Body Length- place tape in the center of the chest and go around the front of the shoulder and to the rear, stopping directly below the ending point used for determining the Back Measurement /SIZE.
IF you have a Heavier Coated dog, this Cooler will sit on TOP of the hair!! Measure accordingly, don't push hair down to measure or Cooler may be too small in chest area, Neck Opening and Jacket Depth.
4.Girth - loosely measure around midpoint of body - at location of Strap Placement
For Custom Fit of Unique Body Types & Heavily Coated Breeds
6. 2nd Belly Strap - larger sizes only.(opt.) 1st strap, measure from center chest, around front of shoulder to behind front leg, allow room for leg movement (just behind line 3 on picture above.) - 2nd strap, measure from center of chest to where line 4 is drawn - (remember plumbing on male dogs)
4.
Bulldog, dachshund, corgi, collie, greyhound, etc.
5. Neck Opening- measure around general neckline opening as jacket would fit - where neck meets the rest of the body, consider haircoat(see #2!) (a greyhound neck is very different than a St. Bernard neck ;-)
